All you ever wanted to know
Asked by Eleanora Cordova
You may be interested in
How long does bacteriostatic water last once opened?
Bacteriostatic water can be used multiple times up to 28 days once opened. Pfizer recommends that after this time you must discard the vial.
How do you store bacteriostatic saline?
Store at 20 to 25°C (68 to 77°F). [See USP Controlled Room Temperature.]
Do you need a script for bacteriostatic water?
Most drug distributors should have bacteriostatic water from reputable sources. ... Work with your local pharmacy as a local means of obtaining bacteriostatic water. This is an over-the-counter product so no prescription from a doctor is needed.
Is sterile water the same as bacteriostatic?
Sterile water is labeled for both injections and irrigations whereas bacteriostatic water is only labeled for injections. Touched on earlier, another key difference is multiple uses. The absence of a bacteriostat in sterile water only allows for a one time use.
Can u drink sterile water?
It is intended for use as an irrigation fluid and not for intravenous administration or administration by other, parenteral routes (e.g., subcutaneous or intramuscular) [see WARNINGS AND PRECAUTIONS]. Sterile Water for Irrigation is not potable water and is not intended for oral administration.
What happens if you inject bacteriostatic water?
If Bacteriostatic Water is injected intravenously without any diluted compound, it may cause some red blood cell lysis because it is not isotonic. Bacteriostatic Water usually does not interact with other drugs; however, some drugs for injection may be incompatible.
How many mL of bacteriostatic water do you mix with HGH?
Reconstitute each 5-mg vial with 1 to 5 mL Bacteriostatic Water for Injection, USP (benzyl alcohol preserved) and each 10-mg vial with 1 to 10 mL of Bacteriostatic Water for Injection, USP (benzyl alcohol preserved).
Is 0.9% sodium chloride the same as bacteriostatic water?
Sodium Chloride, USP is chemically designated NaCl, a white crystalline powder freely soluble in water. Bacteriostatic sodium chloride differs from bacteriostatic water in that it contains added NaCl; bacteriostatic water has no added sodium chloride.
How long will sterile water last?
Boiled water can be kept in sterilized, properly sealed containers in the refrigerator for 3 days or for 24 hours if kept at room temperature out of direct sunlight.
How do you store sterile water for injections?
After initial entry, maintain contents at room temperature (25°C/77°F) and dispense within 4 hours. Exposure of pharmaceutical products to heat should be minimized. Avoid excessive heat. It is recommended the product be stored at room temperature (25°C/77°F).
Can you reconstitute Botox with bacteriostatic saline?
We inject Botox with a small Insulin syringe or 33 gauge needle. ... Patients often question how their Botox is being diluted. We reconstitute our botox with 2 cc of bacteriostatic saline. While the Botox may be reconstituted with different volumes (some use 1cc, other 4cc), the efficacy does not change.
Does benzyl alcohol expire?
There is NO expiration date. Benzyl Alcohol is a stable molecule, and non-reactive.
What is bacteriostatic sodium chloride used for?
What is Bacteriostatic Sodium Chloride Used For? Bacteriostatic Sodium Chloride for Injection is used to dilute or dissolve drugs were required prior to administration by intramuscular, intravenous, or subcutaneous injection.
How do I reconstitute peptides?
Although some peptides will need a stronger solvent to fully dissolve in a solution, as discussed above, sterile distilled water or regular bacteriostatic water is effective in many cases and is the most common solvent or diluent for reconstituting a peptide.
Is one IU of HGH enough?
GH treatment should be started at a low dose, i.e. about 1.0 IU/day, and increased gradually, by about 0.5 IU per month, until the target dose is reached. In the absence of side-effects, the GH dose may be either too low, adequate, or too high.
How much HGH do bodybuilders take?
Dosages for sport-related performance enhancement can be as low as 2IU/day, all the way up to 10IU/day taken by some professional bodybuilders. Relatively few side effects are seen at doses of <4IU/day, but doses of 8⅏� have been known to have permanent side-effects (see acromegaly).
Where do you inject HGH?
HGH should always be injected subcutaneously, i.e., just below the skin and into the fatty tissue. The best sites are the stomach, deltoid, and thigh. Simply pinch along the skin and inject the hormone into the roll of fat. Alternate the sites to avoid bruising.
What is the difference between water for injection and sterile water for injection?
Water for injection is water of extra high quality without significant contamination. A sterile version is used for making solutions that will be given by injection. ... Water for injection is generally made by distillation or reverse osmosis.
Can I use distilled water instead of sterile water?
Sterile water is characterized as water that is free of all microorganisms (like fungi, spores, or bacteria). ... Sterile water should not be confused with distilled water. Distilled water is created by a process of steaming and condensation, and does not contain any minerals like salt, calcium or iron.
Is sterile water a disinfectant?
VAI WFI Quality Water and STERI-WATER Purified Water are an excellent choice for the dilution and preparations of disinfectants, cleaning, rinsing, and may other applications.
Is purified or distilled water better?
Purified water is usually a good option since the purification process removes chemicals and impurities from the water. You should not drink distilled water since it lacks naturally-occurring minerals, including calcium and magnesium, that are beneficial for health.
Can you buy sterile water at Walmart?
Sterile Water for Injection 250 ml - Walmart.com.
What is the difference between sterile water for inhalation and irrigation?
Sterile water for irrigation is often packaged in containers that are typically greater than 1 L in size. Sterile water for inhalation. ... It carries a less stringent specification for bacterial endotoxins than sterile WFI and, therefore, is not suitable for parenteral applications.
Does bacteriostatic water need to be refrigerated?
There are no special rules that need to be followed as far as discard. Keep your unused bacteriostatic water in the container it arrives in. Store the container in a dark place with a residual, resting room temperature that doesn't exceed 80 degrees Fahrenheit and doesn't drop below 60 degrees Fahrenheit.